Cutter Errors & Noise
Why does my vinyl cutter stop mid-cut?
A cutter stopping mid-cut is usually caused by:
- Blade jams or debris buildup
- Power interruptions
- Software or connection errors
This is especially common during long or continuous cutting sessions.
Fix:
- Check blade installation
- Remove debris
- Restart both cutter and software
- Ensure a stable power supply
What are the most common vinyl cutter errors and how do I fix them?
- Carriage / Blade Error: Blade stuck or installed incorrectly → reinstall blade and clean holder
- Media Out / Roller Error: Vinyl loaded unevenly → reload straight and check roller placement
- Software Error: Driver or connection issue → restart software and cutter, update drivers
Most errors are preventable with simple routine checks.
My vinyl cutting machine is making loud or unusual noises. Is this serious?
Unusual noise can indicate:
- Debris inside the machine
- Loose internal parts
- Worn motors or moving components
Experienced operators treat new sounds as early warning signs.
Fix:
- Clean internal areas
- Tighten accessible parts
- Service the machine if the noise continues